Poweramp EH SERIES HYDRAULIC Bedienungsanleitung

POWERAMP • Division of Systems, Inc. • W194 N11481 McCormick Drive • Germantown, WI 53022800.643.5424 • fax: 262.257.7399 • www.docksystemsinc.com •

84111-0004 —November 2003 Rev “B” February 2011Component IdentificationA — LipB — Lip PropC —PlatformD — Lip CylinderE — Powerpack (Motor/Pump/Reservo

94111-0004 —November 2003Rev “B” February 2011This page intentionally left blank

104111-0004 —November 2003 Rev “B” February 2011INSTALLATIONPrepare PitBefore lowering the dock leveler into the pit, thefollowing must be performed:1

114111-0004 —November 2003Rev “B” February 2011INSTALLATION1. Remove any control panel and bumpers that maybe banded to the frame of the dock leveler.

124111-0004 —November 2003 Rev “B” February 2011INSTALLATIONAA— Distance (Leveler FrameHeight)B— Shim Locations (UnderRear Vertical Supports)C— Shim L

134111-0004 —November 2003Rev “B” February 2011INSTALLATIONNOTE: Poweramp dock leveler's are designed with anominal 1/2 in. (12.7 mm) shimming di

144111-0004 —November 2003 Rev “B” February 2011INSTALLATIONA— Front of Dock PitB— Dock Leveler FrameC— Side Pit Curb AngleD— Gap [3/4 in. (19 mm)Mini

154111-0004 —November 2003Rev “B” February 2011INSTALLATION11. With the rear hinge frame angle (F) tight againstthe rear pit curb angle (G), weld the

164111-0004 —November 2003 Rev “B” February 2011DO NOT use the maintenance prop to support theraised platform until the maintenance prop hasbeen prope

174111-0004 —November 2003Rev “B” February 201118. All model leveler's: Install shims at locations (B)using the pyramid or stepped shimming metho

PageSafetyRecognize Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1General Operational Safety Precautions . . . .

184111-0004 —November 2003 Rev “B” February 2011INSTALLATION1. Mount the pushbutton control panel (B) so bottomof control panel-to-dock floor distance

194111-0004 —November 2003Rev “B” February 2011INSTALLATION5. Raise the leveler platform fully by pushing andholding the RAISE button . NOTE: The plat

204111-0004 —November 2003 Rev “B” February 2011OPERATIONOperating InstructionsThe dock leveler operating instructions aredivided into the two methods

214111-0004 —November 2003Rev “B” February 2011OPERATIONNOTE: If end unloading is required, see EndLoading/Unloading Instructions on page 24.For ramp

224111-0004 —November 2003 Rev “B” February 2011OPERATIONEnd Loading/Unloading — Platform at Cross-Traffic Position.End Loading/Unloading — Platform a

234111-0004 —November 2003Rev “B” February 2011MAINTENANCEService Dock Leveler SafelyWhenever maintenance is to be performed under thedock leveler pla

244111-0004 —November 2003 Rev “B” February 2011MAINTENANCEPeriodic MaintenanceTo ensure normal operation of the dock leveler, useonly aircraft hydrau

254111-0004 —November 2003Rev “B” February 2011MAINTENANCERegular maintenance must be performed on aweekly and quarterly schedule. Weekly Maintenance•

264111-0004 —November 2003 Rev “B” February 2011ADJUSTMENTSValve Adjustment ProcedureNOTE: All Poweramp EH leveler's are factorytested and shoul

274111-0004 —November 2003Rev “B” February 2011ADJUSTMENTSS1 Sequence Valve 1Controls the Platform Cylinder. When the leveler hasreached the top of i

1SAFETY4111-0004 —November 2003Rev “B” February 2011Recognize Safety InformationRead and understand the operating instructions andbecome thoroughly fa

284111-0004 —November 2003 Rev “B” February 2011S1 Sequence Valve 1Controls the Platform Cylinder. When the leveler hasreached the top of its travel

294111-0004 —November 2003Rev “B” February 2011This page intentionally left blank

EH leveler's are equipped with the optional AutoReturn To Dock (ARTD) if leveler not interlocked witha truck restraint. The ARTD allows the platf

314111-0004 —November 2003Rev “B” February 2011ADJUSTMENTS6. Turn ON electrical power to the dock leveler.7. Disengage the maintenance prop. 8. Turn t

324111-0004 —November 2003 Rev “B” February 2011Whenever the platform lip is at the full below-dockposition, the following conditions will exist for a

334111-0004 —November 2003Rev “B” February 2011TROUBLESHOOTINGSymptom Possible Cause SolutionPlatform does not rise.Motor does not energize.Motor over

344111-0004 —November 2003 Rev “B” February 2011TROUBLESHOOTINGSymptom Possible Cause SolutionThree-phase units only:Platform does not rise.Motor hums

354111-0004 —November 2003Rev “B” February 2011TROUBLESHOOTINGSymptom Possible Cause SolutionPlatform does not rise.Pump operates inpressure relief mo

364111-0004 —November 2003 Rev “B” February 2011TROUBLESHOOTINGSymptom Possible Cause SolutionPlatform does not rise tofull height.Low hydraulic fluid

374111-0004 —November 2003Rev “B” February 2011PARTSItem Quantity Part Number DescriptionA 1 0961-0085 Proximity Switch with Harness (ARTD Feature On

2SAFETY4111-0004 —November 2003 Rev “B” February 2011Learn the safe way to operate this equipment. Read and understand themanufacturer's instruct

384111-0004 —November 2003 Rev “B” February 2011PARTSFrame and PlatformPMNSRQTABDCEUGFJKLH

394111-0004 —November 2003Rev “B” February 2011PARTSItem Quantity Part Number DescriptionA 1 0595-____1Lip, Welded AssemblyB 1 7823-____2Platform, We

404111-0004 —November 2003 Rev “B” February 2011PARTSHydraulic ComponentsAEPLAADAAABACXWBCEFDGHJORQLKSPTNMYUV

414111-0004 —November 2003Rev “B” February 2011PARTSItem Quantity Part Number DescriptionA 19391-0017 PPAC, Hoke H8, 1.5HP, 1PH, 115/230V, 1.97GPM939

424111-0004 —November 2003 Rev “B” February 2011PARTSHoke / KTI Power Pack AssemblyBALGHPNMKJCACABAAADSZYWXVUTRQDFEO115 Volt 1 PHP1= L1T2+T4+T5=L2(P2+

434111-0004 —November 2003Rev “B” February 2011PARTS1Provide dock leveler serial number and type of installation when calling or faxing orders.2Provid

444111-0004 —November 2003 Rev “B” February 2011PARTSMonarch Power Pack AssemblyPumpMotorGIFHEDAABCJKValve BlockNotes:Low: Voltage: connect as shownHi

454111-0004 —November 2003Rev “B” February 2011Item Quantity Part Number DescriptionA 2 9301-0109 Fitting, #6 SAE to #6 JICB 1 8581-0128 Valve, Seque

464111-0004 —November 2003 Rev “B” February 2011PARTSWeather Seal, Rubber StyleItem Quantity Part Number DescriptionA 1 0192-____* Foam Seal, Rear Hi

474111-0004 —November 2003Rev “B” February 2011PARTSAR = As RequiredNOTE: Brush or track can be purchased separately as replacement parts. Contact fac

3SAFETY4111-0004 —November 2003Rev “B” February 2011Do not use dock leveling device if freight carrier istoo high or too low.Do not overload the dock

484111-0004 —November 2003 Rev “B” February 2011Electrical Note:1 Phase control box show jumper will be the same for 3 phase control box’s.Jumper wire

494111-0004 —November 2003Rev “B” February 2011MISCELLANEOUSCustomer InformationNOTE: Refer to illustration for left/right orientation ofdock leveler

STANDARD PRODUCT WARRANTYSYSTEMS, INC. warrants that its products will be free from defects in design, materials andworkmanship for a pe

4SAFETY4111-0004 —November 2003 Rev “B” February 2011Maintenance Safety PrecautionsALWAYS disconnect electrical power source andground wire before wel

5SAFETY4111-0004 —November 2003Rev “B” February 2011Safety Decal'sEvery 90 days (quarterly) inspect all safety labels and tags to ensure they are

64111-0004 —November 2003 Rev “B” February 2011OWNER’S/USER’S RESPONSIBILITIES1. The owner/ user should recognize the inherent dangers of the interfac

74111-0004 —November 2003Rev “B” February 2011INTRODUCTIONGeneral InformationEH dock leveler's are available in the following sizes,weight capaci